Riddle Buckets (to suit 10Ton – 14Ton Excavators)

Riddle Buckets (to suit 10Ton – 14Ton Excavators)

Supplied by: Multec Limited

Supplier Code: SCOTT-RB/10T-14T

 

The riddle buckets have been designed to have bars on the bottom instead of a solid bottom & are often called skeleton or shaker buckets allowing stones and earth to fall through the bars.

 

Specification:

• High tensile steel
• Hardox cutting edges
• 3 – 13 ton – bars run vertically
• 3″ gap between bars
• 20mm solid bars on the 1.5Ton – 2.5Ton Riddle Buckets
• 25mm solid bars on the 3.0Ton+ Riddle Buckets
• 40mm solid bars on the 13Ton to 18ton Riddle Buckets
• 50mm solid bars on the 20Ton Riddle Bucket
• 20 ton upwards – bars run horizontally
• Same points as digging buckets
• Standard sizes
• Solid, robust and durable
• Will perform in the very toughest environment

 

 

Select your Riddle Bucket’s width  (If applicable to suit your Excavator’s size):

 

• 12″ (300mm / 1ft)
• 15″ (381mm / 1.25ft)
• 18″ (457mm / 1.5ft)
• 24″ (600mm / 2ft)
• 30″ (750mm / 2.5ft)
• 36” (900mm / 3ft)
• 39″ (1000mm / 3.25ft / 1.0m)
• 42″ (1066mm / 3.5ft)
• 48″ (1200mm / 4ft)
• 54″ (1371mm / 4.5ft)
• 60″ (1500mm / 5ft)

 

Please note: Only suitable bucket sizes are available based on the size of your Excavator.

This means you don’t have to worry about buying the wrong size of a bucket for your Excavator as we have already set up each bucket’s listing to help make your purchase easier so you can’t go wrong. e.g. The 4ft Riddle Bucket cannot be selected for an Excavator smaller than 6Ton.

 

The listing Price includes fitted Excavator / Digger brackets to suit, such as: (Just to name a few)

• Hitachi
• JCB
• Kubota
• CAT
• Volvo
• Case etc…

We can do most brackets, let us know the Digger / Excavator Brackets required.

Please let us know the type of bracket required in the “Order Notes” box on the bottom of the check-out page.

 

We may need the following measurements: (As illustrated in diagram #2 with letters A to D references as below)

• Measurement “A”: Pin/Hole Diameter.
• Measurement “B”: Hole centre to hole centre measurement.
• Measurement “C”: Inside to inside measurement.
• Measurement “D”: Pin/Hole centre to base plate measurement. (Determines pin clearance)

 

 

Order & Delivery information (Please Read):

After placing your order & making payment, you will receive a direct email within 48 hours with your “Order Dates” which will be as follows:

• Payment Date (Date of cleared funds)
• Dispatch Date (10+ workings days from cleared funds)
• Arrival Date (2 working days from dispatch)

If the arrival date does not suit, Please contact us as soon as possible so we can re-arrange arrival on a preferred date.

 

Please Note: You will need to have access for the delivery lorry, arrange a way of unloading & sign for arrival.

We also provide the courier’s full contact information before dispatch, so you can contact the courier direct if needed.